Tube Distribution Closure MK II Port en ligne 1x2, 4 ports d'extrémité, 6 ports coulissants (fournis sans joint de câble)

Tube Distribution Closure MK II Suitable for blown fibre and mini cable applications. Robust IP68 construction ensures suitability for direct bury applications. Quick release toggle clips reduce installation time and enable rapid re-entry. Integral pressure relief valve prevents accidental over-pressurisation. For butt applications a plug is available to seal the unused end of the in-line entry port. Can accommodate an in-line blown fibre tube cable/duct between 16,5mm and 40mm in diameter. Two further drop ports on each end can accommodate cables/ducts of between 14,5mm and 24,5mm in diameter. Up to two small cables/ducts between 10 and 11,5mm in diameter can also be accommodated in each of these ports using a manifold. The manifold can also be used to accommodate up to four cables into an end drop port providing the cables are between 8 and 10mm in diameter. A further six drop (3 on each side) allow for cables/ducts between 8 and 11,5mm in diameter, or between 14,5 and 16,5mm in diameter. Drop cable glands, eliminating the need for plugs in unused ports. A tool is available to knock-out the cable ports. The drop cable glands are designed to grip the cables/ducts in two positions. This provides cable retention in both axial and lateral directions. The glands also seal the cable/duct in two positions. Kit content without seals, these need to be purchased seperatly. Specifications: In-Line Ports: 1x2 End Ports: 4 Side Ports: 6 Length: 550mm Width: 290mm Height: 108mm Weight: 2,1kg